Electronic MQTTGateway PCB

First design of the OpenMQTTGatewayPCB

The goal of this project is to make a PCB for the OpenMQTTGateway firmware, which holds almost every module there is available for it. Currently these modules are on the design:

  • IR (Send and receive)
  • RF (Send and receive)
  • PIR
  • DHT
  • Bluetooth (Module is mounted on the backside of the PCB)

Right now the diameter of the PCB is 91mm, so the case will be 100mm or a bit bigger. But if it is possible I will try and shrink the size of the PCB as much as possible.

First PCB design
First iteration of the schematic

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.